Search In
Submit
Advanced Search
Close

Advanced search

Find products
with at least one of the words
with all of the words
with the exact phrase
without the words
priced from $ to $
in this category
Results 1 To 7 for six Sort By:
This search took 0.0834 seconds
Comet Pivot Bolts & Lock Nuts
Item #: 07-160

Comet Pivot Bolts & Lock Nuts


SS Clutch Kit (3/4")
Item #: 15-600
The “SS” Series (six shoes) is the standard clutch on the XCR 120 and Z 120. It comes with wedge shoes, a red racing spring and 10T sprocket. With the wedge shoes it will start at 1900 RPM and will lock up at 2300-2400 RPM. Fits chain #40, #41 and #420.
Quantity
Track Carrier Wheel Kit
Item #: 02-361A
This Wheel Kit bolts into tunnel in order to eliminate unwanted track slap. Kit mounts between the suspension and track allowing the wheel kit to pick up on the track and deflect it away from the suspension. Be sure that you mount it high enough to keep suspension from bottoming out into it. Kit includes shaft with spacers, two 2 3/4” idlers and fasteners. Kits are available in six lengths. Custom lengths available upon request by contacting our tech support.

Ultimax XS Racer 6-Pk
Item #: 07-0861

At the request of race teams, Ultimax XS belts are available in a factory matched set of six belts. Each belt in a 6-Pack is held to tolerances that are three times tighter than the standard XS belt and comes from the same production sleeve for the most repeatable performance anywhere. For complete fitment guide see our XS Belts sold individually.

10% Savings from Retail when purchasing individually.


Arctic Cat Drive Clutch Belt Clearance/Engagement Shim Kit
Item #: 07-711

Arctic Cat Drive Clutch Belt Clearance/Engagement Shim Kit by Thunder Products. Kit includes six .030" thick large diameter washers for engagement adjustment and two .020" thick washers for belt clearance adjustment.

Quantity
Fastener Kit, Lube Tank
Item #: 01-174A
Use this fastener kit to install your lube tank. Includes six each of 1/4-20 bolts and lock washers.
Quantity
Universal Heavy Duty Flywheel Puller
Item #: 16-543

Pull tough flywheels with ease. Strong and built to last for years. This puller is designed with specially shaped slots that allow its use on all two-stroke snowmobile flywheel bolt patterns. Puller includes high quality grade 10.9 bolts, six 6mm and four 8mm.

Quantity

Similar Search Words

Your Recent Searches