Search In
Advanced Search

Advanced search

Find products
with at least one of the words
with all of the words
with the exact phrase
without the words
priced from $ to $
in this category
Results 1 To 9 for shims Sort By:
This search took 0.0416 seconds
Comet Shims
Item #: 07-250

Comet Clutch Shims

Spacer Shims, 5pcs
Item #: 07-006

Spacer Shims, 5pcs. For Quick Change Clutch

Polaris Primary Drive Clutch Spacers
Item #: 07-712

Polaris Primary Drive Clutch Spacers

Clutch Rebuild Kits
Item #: 07-780

Includes 6 Buttons, 12 Button Shims, 3 Rollers, 3 Roller Pins, 9 Multilube Washers and 3 Weight Pins. Wide roller is .540” wide while narrow roller is .360” wide.

Quick Change Racing Clutch
Item #: 07-001

Available in Comet 102C, 108EXP and Polaris P-85. Features a turning dial on the outside of the clutch, which raises and lowers engagement. The spider is splined to allow easy removal for changing shims to maintain belt to sheave clearance. For use with 1 1/4” to 1 7/16” drive belts. Includes weight pins and spacer shims. A longer clutch bolt may be necessary.

Glide Washer Kit
Item #: 07-309
By placing a “Glide Washer” on the end of the spring it will no longer bind on the spider or clutch cover. The kit includes two washers with a baked on lubricity coating and three zinc plated spring shims. Each washer increases engagement 40-50 RPM.

SLP Clutch Rebuild Tool
Item #: 07-281

The Spider Rebuild Tool simplifies removing the pin and roller from a Polaris spider. It self-aligns, removes and aligns new parts including shims and pins. The alignment block was designed to work with the Spider Rebuild Tool to easily remove and install rollers, pins and washers in the spider assembly. Purchase individually or as a combo.

Shim Washers
Item #: 04-650
Use these shim washers to fine tune desired stud height. For 1/4” studs, use aluminum shims. For 7mm studs, use the steel. 48 shims per package. .063" thick

Needle Shim Kit
Item #: 06-808
Mikuni jet needles control fuel metering from 1/4 to 3/4 throttle and have five e-clip positions in .040” increments. Using the .010”, .020” and .030” precision cut shims allow calibration in up to 20 different needle positions. Available in twin carb or triple carb kits.

Similar Search Words

Your Recent Searches